Hardened steel adapter fits any air hammer and is used with 3/8" drive crowfoot. Uses short burst of air power to loosen stubborn fuel line fittings, bolts, nuts, etc. Spring-loaded pin secures adapter to crowfoot.

Eliminates damage by holding pulleys during fastener removal & reassembly. Heat treated steel tool uses a 3/8-inch ratchet or breaker bar and section of old timing belt to hold toothed gears or smooth pulleys securely. Works on camshaft gears, idler gears, water pump pulleys and more. For storage, the toothed belt fits into the slots of tool.

Four different size plastic shims, two for ball joints and two for tie-rods.

Spring type clamp holds U-joint cups in place while drive shaft is out of vehicle.  After removing the driveshaft, compress the spring & place the cups of the tool over the bearing cups of the U-joint.  This will secure the bearing during the repair.